Before plugging in
Check that you have a socket which is compatible with the plug supplied with the fridge. DO
NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE FRIDGE.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30
minutes before switching back on to allow the coolant fluid to settle.
Before filling your fridge
Before storing foods in your fridge, turn the fridge on and wait for 4 hours, to make sure it is
working properly and to allow the fridge to fail to the correct temperature.
4. OPERATING YOUR APPLIANCE
Temperature Control
Your refrigerator is equipped with a thermostat located inside your appliance.
The first time you put your appliance into operation, set the thermostat to “MID” and let it run
empty for 4 hours before storing food in it so that it is sufficiently cooled.
The thermostat goes from the hottest “MIN”, to the coldest “MAX”. Adjust the temperature
as needed. "MID" seems appropriate for use in a home or office (ambient temperature 25°C).
To turn off the refrigerator, turn the thermostat to “OFF”.
The appliance thermostat has 3 settings not including the “OFF” setting. The device
guarantees that the temperature is maintained as long as it is in operation and used under
normal conditions of use.
The temperature inside the appliance can be influenced by many factors: ambient
temperature, exposure to the sun, number of door openings and quantity of food stored...
Slight changes in temperature are perfectly normal.
• Setting "MIN": average temperature of refrigerator compartment 6~10℃
• Setting “MID”: average refrigerator compartment temperature 2~7℃
• Setting “MAX”: average refrigerator compartment temperature 0~5℃
NOTE:
Turning the temperature control to "OFF" position stops the cooling cycle but does not shut
off the power to the refrigerator.
To Next Page
Loading...
Need help?
General
