The device does not
function correctly
✓ Check that the power cord is correctly plugged into the mains.
✓ Check your power module's fuse or circuit, replace if necessary.
✓ The ambient temperature is too low. Try adjusting the room temperature
to fix this problem.
Smell particular in the
device
✓ Check that there is not a damaged food, if it is the case, throw it away.
✓ Check that your food Who feel strong be packed.
✓ You may need to clean the inside.
Noises emitted by the
device
✓ The noises below are absolutely normal:
✓ Compressor noise.
✓ Gurgling similar to the sound of boiling water.
✓ Cracking noises during automatic defrosting.
✓ Clicks before the compressor turns on.
✓ Other unusual noises are caused by the reasons below and may require
you to take action:
✓ Cabinet is not level.
✓ The back of the device is in contact with the wall.
✓ Bottles or containers have fallen or rolled away.
✓ It is normal to hear engine noise frequently; it will need to work harder
under the following circumstances:
✓ The temperature is set lower than necessary.
✓ A large quantity of still hot food has recently been placed in the
appliance.
✓ The temperature outside the device is too high.
✓ The doors are left open too often or too long.
✓ Immediately after installing the device or if it has been turned off for a
long time.
A layer of gel develops
in the compartment
✓ Check that the appliance's air outlets are not blocked by food and ensure
that the food inside the appliance is placed in such a way as to allow
sufficient ventilation.
✓ Make sure the door is securely closed. To remove the gel, please refer
to the chapter “Cleaning and maintenance”.
The indoor
temperature is too high
✓ You may have opened the doors too long or too frequently, an obstacle
could prevent the doors from closing; or the appliance does not have
sufficient space on the sides, behind and above.
The indoor
temperature is too low
✓ Increase the temperature following the instructions in the “Control panel”
chapter.
Doors do not close
easily
✓ Check that the refrigerator is tilted backwards by approximately 10 to 15
mm to allow the doors to close themselves and that nothing inside is
preventing them from closing.
The door is difficult to
open
✓ It is normal for the door to offer some resistance to the opening,
especially when you have just come from the close. A small depression
is created in your device which used to ensure a perfect seal of the door.
It is enough to wait a few moments before of the reopen.
✓ The water tank (located at the back of the cabinet) may not be stable, or
the drainage spout is not positioned to pour water into the container, or
the spout is blocked. You may need to move the refrigerator away from
the wall to check the condition of the spout and container.
To Next Page
Loading...
Need help?
General
