Installation Important!
For electrical connection, carefully, follow the instructions given in this manual.
• Unpack the appliance and check if there are damages on it. Do not connect
the appliance if it is damaged. Report possible damages immediately to the
place you bought it. In this case retain packing.
• It is advisable to wait at least 24 hours before connecting the appliance to
allow the oil to flow back in the compressor.
• This refrigerating appliance is not intended to be used as a built-in
appliance
• Adequate air circulation should be around the appliance, lacking this leads
to overheating. To achieve sufficient ventilation, follow the instructions
relevant to installation.
• Wherever possible the back of the product should not be too close to a wall
to avoid touching or catching warm parts (compressor, condenser) to
prevent the risk of a fire, follow the instructions relevant to installation.
• The appliance must not be located close to radiators or cookers.
• Make sure that the mains plug is accessible after the installation of the
appliance.
ENERGY SAVINGS
• To reduce the power consumption of your device:
• Install it in a suitable location (see "Installing your appliance").
• Keep the doors open for as short time as possible.
• Do not put hot food into your device.
• Ensure the optimal functioning of your device by periodically cleaning the
condenser (see "Routine maintenance of your appliance").
• Ensure the optimal functioning of your device by not allowing too much frost
accumulate in the refrigerator (defrost it when the frost thickness exceeds 5-
6 mm).
• Periodically check the door seals and make sure they always close
effectively. If this is not the case, please contact your after-sales service.
Service
• Any electrical work required to do the servicing of the appliance should be
carried out by qualified electrician or competent person.
• This product must be serviced by an authorized Service Center, and only genuine
spare parts must be used.
To Next Page
Loading...
Need help?
General
