INSTALLATION
RETROFIT SLEEVE PREPARATION
IMPORTANT: Inspect wall sleeve thoroughly prior to installation. Manufacturer does not
assume responsibility for costs or damages due to defects in sleeve or for improper installation.
! WARNING
ELECTRICAL SHOCK HAZARD
Failure to follow this warning could result in personal injury or death.
Disconnect all power to unit to avoid possible electrical shock during
installation.
!
WARNING
Remove any existing foam baffles that are installed on competitive outdoor grille, if present. See Fig. 4.
GE Sleeves Only
GE Metal Wall Sleeve - GE metal sleeve is interchangeable with Frigidaire wall sleeve. See Fig. 5.
GE Plastic Sleeve - Remove bottom seal from plastic sleeve. See Fig. 6.
INSTALLATION OF A FRIGIDAIRE WALL
SLEEVE USING A NON- FRIGIDAIRE GRILLE
Using a Frigidaire wall sleeve with a non-Frigidaire grille requires installation of an Accessory Baffle Kit
(see Fig. 7), which ensures a good seal between the unit and exterior grille to prevent air recirculation. Air
recirculation is a large contributor to performance loss and premature damage to major components.
Notes: Frigidaire stamped grille is interchangeable with GE'S.
Fig.4–Remove Existing Outdoor Grille
Baffles on Competitive Grille
BAFFLES
Fig.5-GE Metal Sleeve
Fig. 6 – Remove Bottom Seal From GE Plastic Sleeve
SLEEVE
BOTTOM SEAL
Fig. 7–Accessory Baffle Kit
Note: Contact your units supplier to get the kit, the actual baffle
kit may look different from the image shown above.
2010 Electrolux Home Products, Inc. All rights reserved.
6
To Next Page
Loading...
