Frigidaire CFHT1713LZ1 - Cool down Period

If yourrefrigeratorhasanautomaticicemaker,noicewill
beproducedduringthefirst24hoursof operation.Air
innewplumbinglinesmaycausetheicemakertocycle
twoorthreetimesbeforemakingafulltrayof ice. With
nousage,it willtakeapproximatelyonetotwodaysto fill
theicecontainer.
Newplumbingconnectionsmaycausethefirstproduction
oficecubestobediscoloredor haveanoddflavor.
Discardicemadeduringthefirst24hours.
Automaticicemakersarealsooptionalaccessoriesthat
maybeinstalledin mostmodelsatanytime. Callyour
localdealerforinformation.
Turning your Ice
Haker On
After the plumbing
connections have been
completed, the water
supply valve must be
opened. Place the ice
container under the ice
maker, pushing it as
far back as possible.
Lower the wire signal
arm to its "down" or
ON position.
Turning your Ice Haker Off
To stop the ice maker, lift the wire signal arm until it
clicksand locks in the "up" or OFF position. The ice
maker also turns off automatically when the ice container
is full.
Your ice maker is shipped from the factory with the
wire signal arm in the ON position. To ensure proper
function for your ice maker, hook up water supply
immediately or turn ice maker OFF by lifting the wire
signal arm until it clicks and locks in the UP position.
If the ice maker is not turned off and the water
supply is not connected, the water valve will
; make a loud chattering noise,
Cool Down Period
To ensure safe food storage, allow the refrigerator to
operate with the doors closed for at least 8 to 12 hours
before loading it with food.
Refrigerator & Freezer Controls
When first turning refrigerator on, move refrigerator
and freezer controls to Normal. This is the
recommended initial setting. After 24 hours, adjust the
controls as needed.
Freezer Control
Refrigerator Control
Tern peratu re Adj ustrnent
- Adjust temperature gradually: move the knob in
small increments, allowing the temperature to
stabilize.
Turning the refrigerator control will change temperatures
in both compartments. For example, if the refrigerator
control is turned to a colder setting, the freezer
control may have to be adjusted to a warmer setting.
Turning the freezer control will change only the freezer
temperature.
To maintain temperatures, a fan circulates air in the
refrigerator and freezer compartments. For good
circulation, do not block cold air vents with food items.
Turning the refrigerator temperature control to "0"
turns off the compressor and prevents the refrigerator
from cooling, but does not disconnect the power to the
light bulb and other electrical components. To turn off
power to your refrigerator, you must unplug the power
cord from the wall outlet.