Bake
Broil
Convection Bake
Convection Roast
On Relay Board
ELEMENTSICoovlovooOoorOLOIcoo'iooFao
Bake Broil Conv Fan ILight Motor L2out Low Speed
P9 P7 Pll J3-5 I J3-3 J3-4 P1 J3-2
X X X* X X X
X X X
X X X X X X
X X X X X X
Cooling Fan
High Speed
J3-1
X
On Display Board
Door Switch
P11-3 / P11-4
Convection Broil
Clean
Locking / Unlocking
Light
Door Open
Door Closed
X
X
X
X
X
X
X
X
X
X
X
E013
E014
EO15
Bad EEPROM.
Lossof Display tail #0.
Lossof Display tail #1.
Lossof Keyboard Tail.
ESECself test failed.
Replace ESEC-UIB.
Check connection P1 on ESEC-UIBand P1 on ESECRotary HI Board (RR).
Check connection P2 on ESEC-UIBand P2 on ESECRotary HI Board (RF).
Check connection J2 on ESEC-UIBand J8 (RF).
An E015 error code may indicate the ESEC-UIBisnot receiving a synchronization
signal from the ESEC-RelayBoard.
Check first if J2 pin 5 on the ESEC-RelayBoard is wired to P4 pin 5 on the ESEC-
UIB. If wiring is good and the problem is still there, replace the ESEC-UIB.If the
problem persists, replace the ESEC-RelayBoard.
WARMERELEMENT/ELEMENTO DE CALENTADOR/ ]
TIMERCONTROL ELEMENT RECHAUD I
MINUTERIE I J"LFLB==,@ N "
P13 BK-4 W-4 @I
450W
TIMER CONTROL
TIMER CONTROL R- 4 _ R- ,4 MINUTERIE
MINUTERIE P11-3
Pll-6 L0 LIMIT THM/TERM. DE LIMITO L0/
THM BASSE LIMITE
When the Warm and Serve Drawer is first turned on, a "Preheat" circuit is established to provide full power (120
volts). When the temperature at the preheat thermostat reaches 150% the thermostat opens, and the warmer ele-
ment starts cycling. If the control is placed on a lower setting, it is possible for the temperature in the drawer to
drop enough to allow the preheat thermostat to close again which will allow the element to reenter the "Preheat"
mode at full power.
To Next Page
Loading...
