SERVICE DATA SHEET 318127057 (0903) Rev. A
Appliance with Electronic Oven Control
This service data sheet is intended for use by persons having electrical and mechanical training and a level of
knowledge of these subjects generally considered acceptable in the appliance repair trade. The manufacturer
cannot be responsible, nor assume any liability, for injury or damage of any kind arising from the use
of this data sheet.
Toavoid the possibility of personal injury and/or property damage, it is important that safe servicing practices be
observed. The following are some, but not all, examples of safe practices.
,
,
Do not attempt a product repair if you have any doubts as to your ability to complete it in a safe and
satisfactory manner.
Before servicing or moving an appliance, remove power cord from electric outlet, trip circuit breaker to Off, or
remove fuse.
3. Never interfere with the proper installation of any safety device.
4. USEONLY REPLACEMENTPARTSSPECIFIEDFORTHISAPPLIANCE.SUBSTITUTIONSMAY DEFEAT
COMPLIANCE WITH SAFETYSTANDARDSSETFOR HOME APPLIANCES.
,
GROUNDING: The standard color coding for safety ground wires is GREENOR GREENWITH YELLOW STRIPES.
Ground leads are not to be used as current carrying conductors. IT ISEXTREMELYIMPORTANTTHATTHE
SERVICETECHNICIAN REESTABLISHALL SAFETYGROUNDS PRIORTO COMPLETION OFSERVICE.FAILURETO
DO SOWILL CREATEA POTENTIALHAZARD.
6. Prior to returning the product to service, ensure that:
• All electric connections are correct and secure.
• All electrical leads are properly dressed and secured away from sharp edges, high-temperature
components, and moving parts.
• All uninsulated electrical terminals, connectors, heaters, etc. are adequately spaced away from
all metal parts and panels.
• All safety grounds (both internal and external) are correctly and securely reassembled.
• All panels are properly and securely reassembled.
1. This unit includes an EOC-Re/ayBoard, EOC-Disp/ay Board, ESEC-UlB,ESEC-RelayBoard and an ESEC-RHIB.
2. The included boards are not field repairable.
3. The oven temperature can be calibrated, see Use and Care Manual.
4. The _ pin on board connectors indicates pin number 1.
EOC : Electronic Oven Control MDL : Motor Door Latch
ESEC: Electronic Surface Element Control DLB: Double Line Break
UIB : User Interface Board RTD: ResistanceTemperature Detector / Oven Probe
RHIB: Rotary Human Interface Board
LED: Light-Emitting Diode
To Next Page
Need help?
General
