Towels Normal Perm Press Delicate Quick Touch Up Timed Dry
Estimated Cycle
Duration ***
60 minutes 50 minutes 40 minutes 20 minutes ** ** **
Temperatures
High
Medium
Low recommended
No Heat not recommended not recommended not recommended not recommended
Dryness Level
More Dry
*
Normal Dry
* *
Less Dry
*
Damp Dry
Options
Press Saver
* *
Cycle Signal
* * * * * * *
* Factory setting
Available settings ** Timed Dry Cycle Only
PN 134420600C
Push button held too long or wedged in the
control panel.
If the dryer stops, the status lights flash and the signal beeps, an error has occured. Press PAUSE/CANCEL. Consult the Error Code Chart below or the "Avoid Service Checklist" in the Owner's
Guide for the possible cause and solution. Make correction, then select a cycle and press START. If the dryer stops, status lights flash again and the beeping continues, please contact service
for assistance.
Error Code Error
Possible Causes Solutions
*** Estimated cycle duration is based on normal
dryness level and factory settings.
Press buttons lightly and release. Disengage
button.
4 beeps Dryer ran too long
Lint filter blocked. Ventilation system clogged.
Dryer overloaded.
Remove lint; wash lint filter to remove softener
sheet residue Clean out ventilation system.
Reduce load size.
These temperatures, dryness levels and options are available with the following cycles:
DRYER SETTINGS CHART
6 beeps Push button does not function
ERROR CODE CHART
To Next Page
Loading...
Need help?
General
