USING YOUR ICE MAKER
8
4. Before the cleaning procedure, please make sure the water drain cap has been
inserted into the appliance; otherwise it will not work properly.
5. Press“ICE/CLEAN” button“ ” for 5 seconds and the screen displays 15M and
the “CLEAN" symbol“ ”(as shown in the picture below). lt will run the cleaning
procedure for 15 minutes and automatically exit. Press this button again during
the cleaning procedure and it will exit immediately.
6. After the cleaning procedure, remove the top cover and the ice basket, rinse the
main water tely. Reservoir and the secondary water reservoir, and then move the
appliance to the edge of the desktop. Make sure that the appliance is placed
steadily. Place a water container under the appliance and remove the drain cap
from the bottom. The dirty water will drain into the water container and
then reinsert the drain cap.
Change water in the water reservoir every 24 hours to ensure a reasonable hygiene
level. If the unitisn't to be used, drain all water and dry the water reservoir.
Secondary
water reservoir
Water drain cap
Main water
reservoir
Clean
For the first time, or the clean procedure has not been running for a long time, it
is highly recommended to run this procedure at first.