4
PPOOSSIITTIIOONN
Place the freezer horizontally on a firm surface, resting
on all four plastic feet. Use a wooden block or similar
object to compensate for any bumps/holes in the
surface.
Temperatures of the external environment have an
impact on the energy consumption of the device.
Therefore:
-
do not put the device to a place exposed to sunshine ore
besides a radiator or oven,
-
put it to a place where the temperature of the
environment corresponds to the climatic classification for
which the device was designed.
Climatic classification Ambient temperature limits
SN from +10 to +32°C
N from +16 to +32°C
ST from +18 to +38°C
T from +18 to +43°C
Do not place the freezer close to sources of heat,
radiators, chimneys, etc., and do not place the freezer in
direct sunlight.
If the freezer has been handled standing on end it should
be allowed to stand in normal position for about 12 hours
before switching it on.
Please ensure that when the appliance is installed it is
easily accessible for the engineer in the event of a
breakdown.
Appliance Description
Control Panel
1 temperature regulator
2 green mains operating light
3 fast freeze switch with amber light
4 red temperature warning light
Starting up
Please clean the appliance interior and all accessories
prior to initial start-up (see section: Cleaning and
Care).
Insert the mains plug of your chest freezer into the mains
supply. Your appliance is then operational.
The green mains operating light (2) and red
temperature warning light (4) show, and the acoustic
temperature warning sounds.
The green mains operating light indicates operation and
must continuously show.
The red temperature warning light tells you that the storage
temperature has not yet been attained.
If you additionally operate the fast freeze switch (3), the
amber pilot light in the switch (3) illuminates, and the
refrigerating unit operates in continuous mode.
When the fast freeze switch is pressed, the acoustic
temperature warnin immediately stops.
INSTALLATION
To Next Page
Loading...
