Frigidaire FFDI331CMS User Manual

8
TROUBLESHOOTING
Before seeking repair or replacement, we recommend that you review the following:
LOUD NOISES:
(Other than those during grinding of
small bones and fruit pits): These are usually caused by
accidental entry of a spoon, bottle cap or other foreign
object. To correct this, turn off electrical switch and water.
After disposer has stopped, remove *splash guard, remove
object with long handled tongs, and replace *splash guard.
UNIT DOES NOT START:
Unplug power cord or turn
either the wall switch or breaker box switch to “OFF”
position, depending on your model and wiring configuration.
Remove stopper and/or *splash guard. Check to see if
turntable will rotate freely using a wooden broom handle. If
turntable rotates freely, replace *splash guard and check re-
set button to see if it has been tripped. Re-set button is red
and located opposite discharge elbow, near the bottom (see
8A). Push button in until it clicks and remains depressed.
If re-set button has not been tripped, check for shorted or
broken wire connecting to disposer. Check electrical power
switch, fuse box or circuit breaker. If wiring and electrical
components are intact, the unit may have internal problems
that require service or replacement.
*Splash guard not used on Top Control/Batch Feed unit.
IF TURNTABLE DOES NOT ROTATE FREELY:
Turn off disposer, then check for any foreign object lodged
between the turntable and grind ring. Dislodge object by
rotating table with a wooden broom handle and remove
object. (see 8B) If no foreign object is present, there may
be internal problems.
LEAKS: If the unit leaks at the top, it may be due to:
1. Improper seating of sink flange (gasket centering, putty
or tightening).
2. Support ring not tightened properly.
3. Defective or improperly installed cushion mount.
If unit leaks at the waste elbow, leak may be due to im-
proper tightening of elbow flange screws.
Call our toll free Help Line with any questions
800-944-9044
CLEANING AND MAINTENANCE
DO NOT ATTEMPT TO LUBRICATE YOUR DISPOSER!
The motor is permanently lubricated. The disposer is self
cleaning and scours its internal parts with each use.
Mineral deposits from your water can form on the stainless
steel turntable, giving the appearance of rust. DO NOT BE
ALARMED,
the stainless steel turntables used will not
corrode.
NEVER put lye or chemical drain cleaners into the disposer,
as they cause serious corrosion of metal parts. If used,
resulting damage can be easily detected an all warranties
are void.
8A 8B
560C525P02 REV A

Frigidaire FFDI331CMS Specifications

General

Brand	Frigidaire
Model	FFDI331CMS
Category	Garbage Disposal
Language	English

Summary

TROUBLESHOOTING

LOUD NOISES

Addresses noises caused by foreign objects and how to resolve them by removing obstructions.

UNIT DOES NOT START

Provides steps to diagnose and fix a disposer that fails to start, including checking the reset button.

TURNTABLE NOT ROTATING

Guides users on checking for and removing foreign objects causing the turntable to jam.

LEAKS

Explains common causes for leaks at the top or waste elbow of the disposer unit.

CLEANING AND MAINTENANCE

NO LUBRICATION NEEDED

States the motor is permanently lubricated and the disposer is self-cleaning.

AVOID CHEMICAL CLEANERS

Warns against using lye or chemical drain cleaners due to corrosion risks and warranty voidance.

PRODUCT REGISTRATION AND SAFETY

IMPORTANT SAFETY INSTRUCTIONS

Presents critical safety guidelines for using the food waste disposer to prevent injury.

GROUNDING SAFETY WARNINGS

Details the importance of proper electrical grounding for safety and avoiding shock hazards.

REMOVAL AND INSTALLATION BASICS

REMOVAL OF OLD UNIT

Provides general instructions for safely removing an existing disposer unit from the sink.

DISHWASHER CONNECTION

Outlines the procedure for connecting a dishwasher to the disposer unit.

MOUNT ASSEMBLY INSTALLATION

MOUNT SYSTEM ASSEMBLY

Step-by-step guide for assembling and installing the disposer's mounting system.

SINK FLANGE INSTALLATION

Instructions on preparing the sink and installing the sink flange for a proper seal.

TIGHTENING MOUNTING HARDWARE

Details on evenly tightening mounting screws for the assembly without overtightening.

GROUNDING INSTRUCTIONS

PLUG-IN CORD GROUNDING

Specific grounding requirements for disposers with plug-in power cords.

HARD-WIRED GROUNDING

Grounding instructions for disposers that are hard-wired into the home's electrical system.

ELECTRICAL CONNECTIONS

WIRING TO HOUSE CURRENT

Instructions for connecting the disposer directly to the house wiring.

ATTACHING DISCHARGE ELBOW

Steps to attach the discharge elbow and connect the disposer to the sink mount.

OPERATING INSTRUCTIONS

NORMAL OPERATION GUIDE

Describes normal operating sounds and general usage procedures for the disposer.

BATCH FEED OPERATING

Specific operating steps and tips for batch feed model disposers.

SUCCESSFUL OPERATION TIPS

Provides advice for optimal performance and longevity, including what not to grind.