SETTING OVEN CONTROLS
MINIMUM AND MAXIMU! CONTROL PAD SETTINGS
Allofthefeatureslistedbelow have minimum and maximum timeortemperaturesettingsthatmay be enteredintothe
control.An ENTRY acceptancebeep willsound each timea controlpad istouched (theacceptancebeep on the Oven
Lockout pad isdelayed3 seconds).
An ENTRY ERROR tone (3 shortbeeps)willsound ifthe entryofthetemperatureortimeisbelowthe minimum orabove
the maximum settingsforthe feature,
FEATURE
PREHEAT
BAKE
BROIL
CONVECTION BAKE
CONVECTION ROAST
CONVECTION BROIL
PIZZA
CHICKEN NUGGETS
TIMER
CLOCK TIME
DELAY START
BAKE TIME
SELFCLEAN TIME
12 Hr. Mode
24 Hr. Mode
12 Hr. Mode
24 Hr. Mode
12 Hr. Mode
24 Hr. Mode
12 Hr. Mode
24 Hr. Mode
MINIMUM TEMP./TIME M_!MUM TEMP,/TIME
170°F/77°C 550°F/288°C
170°F/77°C 550°F/288°C
400°F/205°C 550°F/288°C
170°F/77°C 550°F/288°C
170°F/77°C 550°F/288°C
400 ° F/205°C 550 ° F/288°C
170°F/77°C 550° F/288°C
170° F/77°C 550° F/288°C
0:01 Min. 11:59Hr.!Min.
0:01 Min. 11:59 Hr,/Min.
1:00 Hr.!Min. 12:59 Hr./Min,
0:00 Hr./Min. 23:59 Hr./Min.
1:00 Hr.!Min, 12:59 Hr./Min.
0:00 Hr./Min. 23:59 Hr,/Min.
0:01 Min. 5:59 Hr.iMin.
0:01 Min, 5:59 Hr./Min.
2 hours 4 hours
SETTING THE CLOCK
The SET CLOCK pad isused to set the clock. The clock may
be set for 12 or 24 hour time of day operation. The clock
has been preset at the factory for the 12 hour operation.
When the range is first plugged in, or when the power
supply to the range has been interrupted, the timer in the
display will flash.
To set the clock (example below for 1:30)
1. Press SET CLOCK. "CLO" will appear in the display.
2. Press 1 30 pads to set the time of day to 1:30. "CLO"
will stay in the display.
3. Press START. "CLO" will disappear and the clock will
start.
CHANGING BETWEEN 12 OR 24 HOURTIME
OF DAY DISPLAY
1. Press and hold SET CLOCK for 6 seconds. "CLO" will
appear in the display.
2. CONTINUEholdingthepad until":[2HrdAY"or"24Nr
{IAY" appears in the displayand the controlbeeps
once,
3. Press SELl: CLEAN to switch between the 12 and 24
hour time of day display. The display will show either
"12Hr dAY" or "24Hr dAY".
4. PressSTART to acceptthechange orpressCANCEL to
rejectthechange.
5. Reset the correct time as described in To set the Clock
above. Please note that if the 24 hour time of day mode
was chosen, the clock will now display time from 0:00
through 23:59 hours.
20
To Next Page
Loading...
