CARE & CLEANING
Care and c|eaning tips
Part Cleaning Agents
Interior & • Soap and water
Door Liners , Baking soda and
water
Door - Soap and water
Gaskets
Drawers & • Soap and water
Bins
Glass
Shelves
Toe Grille
Exterior &
Handles
• Soap and water
• Glass cleaner
- Mild liquid sprays
, Soap and water
, Mild liquid sprays
e Vacuum
• Soap and water
, Non abrasive glass
cleaner
Exterior & , Soap and water
Handles
(Stainless
Steel Models
Only) • Stainless steel
cleaners
Tips and Precautions
• Use two (2) tablespoons of baking soda in one (i) quart of warm water.
• Be sure to wring excess water out of sponge or cloth before cleaning
around controls, light bulb or any electrical part.
• Wipe gaskets with a clean soft cloth.
• Use a soft cloth to clean drawer runners and tracks.
• Do not wash any removable items (bins, drawers, etc.) in dishwasher.
• Allow glass to warm to room temperature before immersing in warm water.
• Remove toe grille (see Installation Instructions).
• Vacuum both sides and wipe with sudsy cloth or sponge. Rinse and dry.
° Do not use commercial household cleaners containing ammonia, bleach or
alcohol to clean handles.
• Use a soft cloth to clean smooth handles.
• Do not use a dry cloth to clean smooth doors.
• Never use CHLORIDE or cleaners with bleach to clean stainless steel.
• Clean stainless steel front and handles with non-abrasive soapy water and a
dishcloth. Rinse with clean water and a soft cloth.
, Use a non-abrasive stainless steel cleaner. These cleaners can be purchased
at most home improvement or major department stores. Always follow
manufacturer's instruction. Do not use household cleaners containing
ammonia or bleach.
, NOTE: Always clean, wipe and dry with grain to prevent scratching.
• Wash the rest of the cabinet 'with warm water and mild liquid detergent.
Rinse well and wipe dry with a clean soft cloth.
Ice Chute Extension
The ice chute extension is
designed to better direct ice
flow into containers.
Removing the Ice
Chute Extension For
Cleaning
I Turn the refrigerator
off using the button
on the control
panel (refer to the
"Controls" section of
this Manual).
2 Press inward firmly on
the front of the chute
and pull down.
3 Turn your refrigerator
back on.
Pull Down
Installing the Ice
Chute Extension
1 Turn the refrigerator off ............
using the button on the
control panel (refer to
the "Controls" section of
this Manual).
2 Align the extension with
the ice chute so that the
snap clips are just inside
the front edge of the chute.
3 Push upward until the extension snaps into place.
4 Turn your refrigerator back on.
31
To Next Page
Loading...
