Care and cleaning tips
Interior & - Soap and water
Door Liners - Baking soda and
water
Use two tablespoons of baking soda in one quart of warm water.
Be sure to wring excess water out of sponge or cloth before cleaning
around controls, light bulb or any electrical part.
Drawers & - Soap and water
Bins
Use a soft cloth to clean drawer runners and tracks.
Do not wash any removable items (bins, drawers, etc.) in dishwasher,
Toe Grille
Soap and water
Mild liquid sprays
Vacuum
Remove toe grille (see Installation Instructions).
Vacuum both sides and wipe with sudsy cloth or sponge. Rinse and dry.
Exterior & = Soap and water
Handles = Stainless steel
(Stainless cleaners
Steel Models
Only)
o
o
Never use CHLORIDE or cleaners with bleach to clean stainless steel.
Clean stainless steel front and handles with non-abrasive soapy water and
a dishcloth. Rinse with clean water and a soft cloth.
Use a non-abrasive stainless steel cleaner, These cleaners can be
purchased at most home improvement or major department stores. Always
follow manufacturer's instruction. Do not use household cleaners containing
ammonia or bleach.
NOTE: Always clean, wipe and dry with grain to prevent scratching.
Wash the rest of the cabinet with warm water and mild liquid detergent.
Rinse well and wipe dry with a clean soft cloth.
Ice Chute Extension
(select models)
The icechute extension is
designedto better direct
ice flow into containers.
Removing the Ice
Chute Extension
For Cleaning
1 Turn the refrigerator
off using the button
on the control
panel (refer to the
"Controls" section of
this Manual).
2 Press inward firmly
on the front of the
chute and pull down.
3 Turn your
refrigerator back on.
Press Here
Firmt'
/ Pull Down
Installing the Ice
Chute Extension
1
2
3
4
Turn the refrigerator off
using the button on the
control panel (refer to
the "Controls" section of
this Manual).
Align the extension with
the ice chute so that the
snap clips are just inside
the front edge of the chute.
Push Upward Until the
Extension Snaps In Place
Push upward until the extension snaps into place.
Turn your refrigerator back on.