Frigidaire FLS26Z2GK - User Manual

TO BE REMOVED BY THE CUSTOMER AFTER INSTALLATION IS COMPLETE
INSTALLATION CHECKOFF LIST
Doors
Handles are secure and tight
Door seals completely to cabinet on all sides
Freezer door is level across the top
Leveling
Refrigerator is level, side to side and tilted 1/4” (6mm) front to back
Toe grille is properly attached to refrigerator
Cabinet is setting solid on all corners
Electrical Power
House power turned on
Refrigerator plugged in
Ice Maker
House water supply connected to refrigerator
No water leaks present at all connections - recheck in 24 hours
Ice Maker is turned ON.
Ice & Water Dispenser operates correctly
Front filter must be flush with filter housing (some models)
Final Checks
Shipping material removed
Fresh Food and Freezer controls set
Crisper Humidity controls set
Registration Card sent in
Refer to your Owner’s Use and Care Manual for
additional information about your refrigerator.
• Load refrigerator from side of cabinet only.
• Do not run retaining straps over handles.
• Do not over-tighten retaining straps.
• Never use refrigerator handles to move the
refrigerator.
• Remove tape from doors only after unit is in
place.
HAND TRUCKING
1
Remove Shipping material. (Features may vary per model.)
2
SHIPPING MATERIAL
3 PIECES OF TAPE
1 PIECE OF TAPE OR
2 BLUE SHIPPING CLIPS
1 PIECE OF TAPE
1 PIECE OF TAPE
1 PIECE OF TAPE
SHELF SPACER WITH TOE GRILLE
1 PIECE OF TAPE
1 PIECE OF FOAM
OR CARDBOARD
2 WIRE TIES
(All wire baskets
will have 2 wire
ties)
3
Connect water supply - check for water leaks.
Turn icemaker OFF if water supply is not
connected immediately. Connecting to a
reverse osmosis system is not recommended.
WATER SUPPLY
eçìëÉ
éäìãÄáåÖ
äáåÉ
t~íÉêäáåÉ=Üççâ ìé
WATER SUPPLY
_É=ÅÉêí~áå
íÜÉ=ï~íÉê=î~äîÉ=áë
çéÉå=~åÇ=íÜÉêÉ
~êÉ=åç=äÉ~âëK
qÜÉ=ï~íÉê=î~äîÉ
çå=íÜÉ=Ä~Åâ=çÑ
íÜÉ=êÉÑêáÖÉê~íçê
ïáää=`äáÅâL_ìòò=áÑ
íÜÉ=ï~íÉê=î~äîÉ
áë=ÅäçëÉÇK
4
Allow the following clearances for ease of installation, proper air circulation, and
plumbing and electrical connections:
• Sides & Top..........3/8”
• Back.......................1”
INSTALLATION CLEARANCES
NONO
NONO
NO
TETE
TETE
TE
If you are installing your refrigerator beside a wall, leave 1/2” minimum between
hinges and wall to allow for the door to swing open.
7
8
ICEMAKER
IF YOU ARE DISSATISFIED WITH THE
INSTALLATION, PLEASE CALL THE STORE
YOU PURCHASED IT FROM.
9
√ See “Normal Operating Sights & Sounds” in the Use & Care Manual
so you understand the sounds you may hear once your refrigerator is
running.
√ Please read entire Use & Care Manual to become aware of important
safety instructions and to become familiar with your new refrigerator.
√ Send in Registration card to register your refrigerator.
√ Congratulations! You are ready to enjoy your new refrigerator.
P/N: 241811501
Copper water line
from household water supply
(Include enough tubing in loop to allow
moving refrigerator out for cleaning.)
Steel
Clamp
Plastic Water Tubing
to Ice Maker
Fill Tube
Brass
Compression
Nut
If you need to remove the doors to get your refrigerator in the house, please See
Door Removal Instructions in your Use & Care Manual.
OFF
ON
OR
ON
OFF
Wire
Signal Arm
5
LEVELING AND ADJUSTING
Toe Grille Adjustable Front Roller
(some models)
All four corners of refrigerator must rest firmly on a solid floor. Your
refrigerator has adjustable rollers to help level it and to adjust the doors.
To level cabinet or change door height:
1. Remove toe grille.
2. Use a screwdriver, 3/8” wrench, or nutdriver to adjust the
rollers. To raise cabinet or door, turn screw clockwise. To
lower cabinet or door, turn screw counterclockwise.
6
CONTROLS
When changing control settings, wait 24 hours before making additional adjustments.
Ensure icemaker to turned ON. Check to see that the Ice & Water Dispenser is operating
correctly. (See Automatic Ice & Water Dispenser Features in
Use & Care Manual .)
TO REMOVE DOORS (if necessary)

Summary

Installation Checkoff List

Doors

Verify door security, seals, and levelness for proper closure.

Leveling

Ensure refrigerator is level, tilted correctly, and cabinet is stable.

Electrical Power

Confirm house power is on and the refrigerator is plugged in.

Ice Maker

Check water supply connection, leaks, and ice maker operation.

Final Checks

Verify shipping material removal, control settings, and registration.

Hand Trucking

Safe Handling and Tape Removal

Properly load from side, avoid handles, do not overtighten straps, remove door tape last.

Shipping Material

Material Identification and Removal

Identify and remove all shipping materials like foam, tape, and clips.

Water Supply

Connection and Leak Check

Connect water supply, check for leaks, turn icemaker OFF if not connected.

Installation Clearances

Required Spacing

Maintain 3/8" sides/top and 1" back clearance for air circulation.

Leveling and Adjusting

Cabinet and Door Adjustment

Use adjustable rollers to level the cabinet and adjust door height.

Controls

Temperature Settings

Adjust Freezer and Fresh Food temperature controls for desired settings.

Icemaker

Operation and Dispenser Check

Ensure icemaker is ON and check Ice & Water Dispenser operation.

To Remove Doors

Door Removal Procedure

Refer to Use & Care Manual for instructions on removing doors if necessary.

Final Steps and Congratulations

Review and Registration

Read manual, send registration card, and enjoy your new refrigerator.

Frigidaire FLS26Z2GK Specifications

General

Brand	Frigidaire
Model	FLS26Z2GK
Category	Refrigerator
Ice Maker	Yes
Water Dispenser	Yes
Energy Star Certified	Yes
Configuration	Side by Side
Type	Freestanding
Defrost Type	Automatic