1-800-944-9044 (United States) Visit our web site at
1-800-265-8352 (Canada) www.frigidaire,com,
Before calling for service, review this list. It may save you time and expense. This list includes com-
mon occurrences that are not the result of defective workmanship or materials in this appliance.
PROBLEM CAUSE CORRECTION
APPLIANCE OPERATION
Appliance *
does not run.
e
e
e
.
Appliance is plugged into a
circuit that has a ground
fault interrupt.
Temperature Control is in the
OFF position.
Appliance may not be
plugged in or plug is loose.
House fuse blown or tripped
circuit breaker.
Power outage.
Use another circuit. If you are unsure
about the outlet, have it checked by a
certified technician.
See ELECTRONIC CONTROL section.
* Ensure plug is tightly pushed into outlet.
* Check/replace fuse with a 15-amp time-delay
fuse. Reset circuit breaker.
o Check house lights. Call local electric company.
Appliance I" Room or outside weather - It's normal for the appliance to work longer
runstoo muchl is hot. I under these conditions.
or too long, - Appliance has recently been , It takes 24 hours for the ap liance to cool
P
disconnected for a period down completely.
of time. I
o Large amounts of warm I* Warm food will cause appliance to run more
or hot food have been I until the desired temperature is reached.
, stored recently. I
Door is opened too frequently, • Warm air entering the appliance causes it to
or too long. run more. Open door less often.
Door may be slightly open. _* See "DOOR PROBLEMS".
Temperature control is set • Turn control knob to a warmer setting. Allow
' too low. I several hours for the temperature to stabilize.
I" Gaskets are dirty, worn, o Clean or change gasket. (See Care and
I cracked, or poorly fitted. I Cleaning Chart). Worn, cracked or poorly
fitting gaskets should be replaced.
APPLIANCE TEMPERATURES
Interior ap= - Temperature control isset
pliance tern- tOO lOW,
Temperature • Temperature control is set
inside appli = too warm.
ante is too
• Door is opened too frequently
warm, or too long.
Door may not be seating properly.
Large amount of warm
or hot food has been
stored recently.
Unit has recently been
disconnected for a period
of time.
"LO" is _ Contr0! has been locked,
Set control to a warmer setting. Allow several
hours for temperature to stabilize.
• Turn control to a colder setting. Allow several
hours for temperature to stabilize.
Warm air enters the appliance every time the
door is opened. Open door less often.
• See"DOOR PROBLEHS'.
• Wait until the appliance has had a chance to
reach its selected temperature.
* Appliance requires 24 hours to cool
down completely.
Press the CONTROL LOCK key for three
displayed on,, seconds to un!ock.
control, "
"E7", "E8", • The control has registered an * For toll-free telephone support in the U.S.
"Eg"is error code. and Canada: 1-800-374-4432
displayed on
control.
.......................................
To Next Page
Loading...
