1=800=944=9044 (United States)
1=800=265=8352 (Canada)
Visit our web site at
www.frigidaire.com.
CONCERN POTENTIAL CAUSE i COMMON SOLUTION
AUTOHATIC ICE MAKER
Ice maker is not mak- • Ice maker power switch is Off.
ing any ice. • Ice maker has small cube
caught in mechanism.
Saddle valve on cold water
pipe is clogged or restricted by
foreign material.
Ice maker is not mak- ice maker is prOduCing less ice
ing enough than you expect.
, Check to see ifwater dispenser
is dispensing slower than normal
Ice maker will not stop • Ice maker wire signal arm is
making ice. being held down by some item
in the freezer.
Icec_bes are freezing • cubes are not beingused
together, frequently enough:
• Ice cubes are hollow (partially
frozen cubes with water inside),
e Freezer control isset too warm.
• Turn power switch to On ("1:") position.
• Remove small cube from ice maker. The ice and water
filter cartridge may be clogged. Replace filter cartridge.
Turn off household water line valve. Remove valve. En-
sure that valve is not a self-piercing saddle valve. Clean
valve. Replace valve if necessary.
ice maker produces approximately four (4)pounds of
ice every 24 h0urs depending 0n usage conditions.
is:replace the ice and water filter cartridge:
• Move item and release wire signal arm. Remove any ice
cubes that are frozen together over the wire signal arm.
i Remove ice container and discard ice from COntainer. Ice
maker wi!l produce fresh supplyl
The ice and water fi ter cartridge may be clogged: Replace
filter cartridge.
• Set freezer control to colder setting, Allow 24 hours
' temperature to stabilize.
OPENING/CLOSING OF DOORS/DRAWERS
DOOr(s) will not close,. Door was closed too ha caus:
ing other door to open slightly.
• Refrigerator is not level: It
slightly:rockson the floor when moved
• Refrigerator is touching a wall
or cabinet,
I
Drawers are difficult to • Food is touching shelf on top of
move. drawer.
• Track that drawers slide on is
dirty.
' Close both doors gently,
' Ensure floor is level and solidi and Can adequately support
the refrigerator. Contact a carpenter tO correct a sagging
or sloping floor.
, Ensu[e floor is leve! and solid; and can adequately support
the refrigerator. Contact a carpenter to correct a sagging
or sloping floor.
• Remove top layer of items in drawer.
• Ensure drawer is properly installed on track.
• Clean drawer, rollers, and track. See Care & Cleaning.
To Next Page
Loading...
