12
DOOR HANDLE INSTALLATION
Door Handle Mounting Instructions
1. Remove handle and any protective
packaging from inside the appliance.
2. Position handle end caps over upper
and lower pre-installed shoulder
bolts (A) that are fastened into door,
ensuring the holes for the set screws
are facing away from the hinge.
3. While holding handle firmly against
door, fasten upper and lower Allen set
screws (B) with supplied Allen wrench.
A
B
CAUTION
Wear gloves and use extreme CAUTION
when installing these handles. The round-
ed end of the handles may be sharp.
NOTE
All set screws should be tightened and
sub-flush (Allen set screw should be
seated just below the surface of the
end cap) of handle end cap. The end
caps should be drawn tight to door
with no gaps.
To Next Page
Loading...
Need help?
General
