Timed Dry
Estimated
drying time ***
60 minutes 50 minutes 40 minutes 20 minutes 30 minutes 45 minutes
15 to 90
minutes
Temperatures
High
*
Medium-High
*
*
Medium
*
*
*
Low
*
No Heat
** ** ** **
Dryness Level
More Dry
Normal Dry
*
*
*
Less Dry
*
Damp Dry
Options
Shrink Guard
*
Press Saver
*
*
Cycle Signal
*
*
*
*
*
*
*
Press buttons lightly and release.
Disengage button.
Lint filter blocked. Ventilation system clogged. Dryer overloaded.
Push button held too long or wedged in the control panel.
If the dryer stops, the status lights flash, the signal beeps and a code is displayed, an error has occured. Press PAUSE/CANCEL twice. Consult the Error Code Chart below or the
"Avoid Service Checklist" in the Owner's Guide for the possible cause and solution. Make necessary corrections, then select a cycle and press START. If the dryer stops, the status
lights flash again, the beeping continues and the code reappears, please contact service for assistance.
* Factory
Available ** Not
*** Estimated cycle duration is based on normal
dryness level and factory settings.
setting settings recommended
Solutions
Remove lint; wash lint filter to
remove softener sheet residue
Clean out ventilation system.
Reduce load size.
DRYER SETTINGS CHART
AVAILABLE CYCLE SETTINGS - These temperatures, dryness levels and options are available with the following cycles:
ERROR CODE CHART
Push button does not function
Error
Dryer ran too long
Possible Causes
To Next Page
Loading...
