19
Internal Water Dispenser Control Display Mode Views
Your display is equipped with a sleep and lock mode to prevent accidental changes
to the unit settings during opening and closing of the doors. When both doors are
closed, the display will be in sleep mode. When either door is first opened, the display
will be in lock mode where all the current settings are visible but dimmed.
Pressing any button on the display will awake the display and a tone will be played.
All settings will then be fully lit. Touch the display again to change any setting.
If there is no button pressed for 10 seconds while any door is open, the display will
default back to lock mode.
Awake Mode View Lock Mode View Sleep Mode View
CONTROLS AND SETTINGS
To Next Page
Loading...
Need help?
General
