Drying Procedures
Follow fabric care label instructions_
Place small items in a mesh bag
Fill dryer drum 1/3 to 1/2 full
Follow the guidelines below for preparing the load for drying
Read the Operating Instructions card for operating },our specific model
Always read and follow fabric care labels and laundry product labels.
To reduce the risk of fire, electrical shock, or injury to persons, read
Important Safety Instructions, pages 2-3, before operating this dryer.
1, Prepare items for drying.
Dr}, items of similar fabric, weight and construction in the same load.
Separate dark items from light-colored items Separate items that shed lint from
those that attract lint. If an item sheds lint, turn it inside out
Be sure buckles, buttons and trim are heatproof and won't damage the drum finish.
Close zippers, fasten hooks and Velcro®-Iike fasteners_ Tie strings and sashes to
prevent snagging and tangling
If possible, turn pockets inside out for even drying
Check for stains which may not have been removed in washing_ Dryer heat may
permanently set some stains_ Repeat stain removal process before drying
Place small items in a mesh bag to prevent tangling and for easy removal
2. Check that lint screen is clean and in place,
3, Load the dryer,
The average load will fill the drum 1/3 to 1/2 full_ Items need room to tumble freely
for even drying and less wrinkling Do not overload dryen
When drying large items, dry only 2 or 3 at a time. Fill out the load with small and
medium sized items.
For delicate or very small loads, add 2 lint-free towels for better drying, less
wrinkling, and to prevent grease stains caused by fabric softener sheets.
Do not overdry items Overdrying can cause wrinkling, shrinkage, harshness, and
a build-up of static electricity, which can produce more lint
If desired, add a dryer fabric softener sheet
4, Close the dryer door and set dryer controls (some models),
See Operating Instructions card for your specific model controls.
5. Turn cycle selector clockwise to the desired setting,
6. 5tart the dryer.
, Push Start Button for 2 seconds or turn the START knob clockwise to ON, hold for
1-2 seconds and release_
To add or remove items when the dryer is running, open the door_ The dryer will
always stop when the door is opened Allow the drum to come to a complete stop
before reaching inside
To restart dryer, close the door then push the Start Button for 2 seconds or turn
the START knob clockwise to ON, hold for 1-2 seconds and release_
The dryer will not start if the cycle selector is in the OFF position
7, When the cycle ends, remove items immediately and hang or fold. If load is
removed before the cycle ends, turn cycle selector to OFF
Feature5
Place the front bar under
the lip of the lint screen opening
Cycle Signal Control (some models)
When the Cycle Signal Control isON, a signal will sound at the end of each cycle and during
the Press Saver setting (some models) The volume is adjustable on some models,
Drum Light (some models)
A drum light will come on w,henever the door isopened to illuminate the dryer drum during
loading and unloading Closing the door turns off the light
Reversible Dryer Door
Your dryer is equipped with a reversible door The door can be hinged on the right or left
side_ Refer to the INSTALLATION INSTRUCTIONSfor directions on changing the door
Drying Rack (some models)
Use the drying rack to dry items which should not be tumble dried,
1_ Open the dryer door and remove the lint screen_
2, Insert drying rack into the dryer drum Placethe front bar under the lip of the lint screen
opening_
3, Placeitems to be dried on top of the rack Weight should not exceed I0 Ibs_Leavespace
between items, but do not Jetitems hang over the sides or through the grids_ Do not
tumble other items when using the drying rack
4, Select a timed dry setting best suited for items being dried Use only the Air Fluff (no
heat) temperature setting for items containing plastic, foam rubber, rubber-like
materials, feathers or down
B, When itemsare dry, remove the rack and replace the lint screem If lint screen is not in
place, tumbling items could enter the exhaust system and cause damage to the dryer,
3
To Next Page
Loading...
