1-800=944=9044 (United States)
1-800=265-8352 (Canada)
Visit our web site at
www.frigidaire.com.
CONCERN POTENTIAL CAUSE i COHHON SOLUTION
AUTOHATIC ICE lAKER
Ice maker is net mak-
ing any ice.
• Ice maker power switch is Off. • Turn power switch to On ("I") position.
• Ice maker has small cube • Remove small cube from ice maker. The ice and water
caught in mechanism, filter cartridge may be clogged. Replace filter cartridge.
• Saddle valve on cold water • Turn off household water line valve. Remove valve. En-
pipe is clogged or restricted by sure that valve is not a self-piercing saddle valve. Clean
foreign material, valve. Replace valve if necessary.
' ice maker is producing less ice • The ice maker produces approximately 215 pounds of ce
than you expect, every 24 hours depending on usage conditions.
Check to see ifwaterldispenser , * If it iS, rep!ace the ice and water fi!ter cartridge.
Is alspenslng slower man normal.
• Ice maker wire signal arm is • Move item and release wire signal arm. Remove any ice
being held down by some item cubes that are frozen together over the wire signal arm.
in the freezer.
, Ice cubes are not being used • Remove ice container and discard ice from container. Ice
frequent!y enough, maker wi!l produce fresh supply.
-Ice cubes are hollow (partially The ice and water fi ter cartridge may be clogged: Replace
frozen cubes with water filter cartridge.
• Set freezer control to colder setting. Allow 24 hours
temperature to stabilize.
ICE DISPENSER
Dispenser will not disL Ice storage €ontainer is empty.
pense ice.
• Freezer temperature is set too
warm.
Household water line Vaive is
not open,
i
, Ice dispensing arm has been held
in for more than 4'5 minutes.
Ice dispenser is • Ice has melted and frozen
jammed, around auger due to infrequent
use, temperature fluctuations,
and/or power outages.
• Ice cubes are jammed between
ice maker and back of ice
container.
' When the first supPiy Of ice is dropped into the container,
the dispenser should operate.
• Turn freezer control to a higher se_ing so that ice cubes
will be made. When first supply of ice is made, dispenser
should operate.
Open household water line valve. Allow sufficient time
for the ice to be made. When ice is made, the dispenser
should operate.
, Motor is overloaded. Motor over load protector will reset in
approximately 3 minutes. Ice can then be dispensed.
• Remove ice container, thaw, and empty the contents.
Clean container, wipe dry, and replace in proper position.
When new ice is made, dispenser should operate.
• Remove ice cubes that are jamming the dispenser.
OPENING I CLOSING OF DOORS I DRAWERS
Door(s) will net close. • Door was closed too hard, caus-
ing other door to open slightly.
• Refrigerator is not level. It
rocks on the floor when moved
slightly.
• Refrigerator is touching a wall
or cabinet.
Close both doors gently.
Ensure floor is level and solid, and can adequately support
the refrigerator. Contact a carpenter to correct a sagging
or sloping floor.
Ensure floor is level and solid, and can adequately support
the refrigerator. Contact a carpenter to correct a sagging
or sloping floor.
Drawers are difficult to ' Food is touching shelf on LoPof • Remove top !ayei of items in drawer.
move; drawer. • Ensure drawer is properly installed on track.
• Track that drawers slide on is • Clean drawer, rollers, and track, See Care & Cleaning,
dirty, i
To Next Page
Loading...
