Frigidaire PLES399ECI - Page 2

Setting the Clock
The _/_c-'_pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
time in the display will flash (See Figure 1).
Figure 1
INSTRUCTIONS
To set the clock (example below for 1:30)
1. Press _. "CLO" will appear in the display (Figure 2).
2. Press _ @ @ pads to set the time of day to 1:30(Figure3).
"CLO" will stay in the display. Press '
and the clock will start (Figure 4).
"CLO" will disappear
Changing between 12 or 24 hour time of day display
1. Press and hold _oc_ for 7 seconds (Figure 3). After 7 seconds,
"12h" (Figure 5) or "24h" (Figure 6) will appear in the display and
the control will beep once.
2. Press _ea_ to switch between the 12 and 24 hour time of day
display. The display will show either "12h" (Figure 5) or "24h"
(Figure 6).
3. Press Ito accept the change or press _/_f_ to reject the
change.
4. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours.
PRESS
_for 7 seconds
®
DISPLAY
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6