CLEANING AND CARE 23
Disconnect the power cord or leave the door open to deactivate the oven during
cleaning. Disconnect the power cord before replacing filters and lights.
• Disconnect power to the microwave oven at the
circuit breaker panel or by unplugging.
• Remove the vent grill mounting screws.
• Pull the vent grill away from the unit.
• Remove the charcoal filter and replace with part
number.
• Put the vent grill back on unit.
CHARCOALFIL TER REPLACEMENT
Charcoal Filter installed in your microwave oven, is
used for non vented, recirculated installation. The
filter should be changed every 6 to 12 months
depending on use.
• Remove the light cover mounting screw, open
light. light cover by carefully pulling up on the
front edge.
• Remove the LED bracket and light assembly.
Remove the LED light from the bracket by
removing the mounting screw and replace only
with part 5304499540.
To order parts call 800-599-7569.
• Re-install LED light to the bracket with
mounting screw. When re-installing mounting
screw be careful not to damage the LED light.
• Reconnect LED light to the harness and place
the LED light assembly back into the light cover.
• Replace the microwave oven light cover by
carefully pushing into place and mounting the
screw.
• Put the vent grill back on unit.
OVEN LIGHT REPLACEMENT
Remove (he vent grill per charcoal filter replace-
ment instructions.
To Next Page
Loading...
