Insert FROG
@ease Mineral
Cartridge and FROG
@ease SmartChlor
Cartridge into the
two openings on the
outside of the lter
system. Push
cartridges in until
they are latched.
Shock the hot tub with FROG
Maintain
®
, a non-chlorine shock
for easy single-dose shocking
when you replace the FROG @ease
SmartChlor Cartridge or once a
month.
5.
NOTE: pH is affected by bather load, chemicals used,
evaporation and the make-up of your source water so
maintaining water balance regularly is important.
Troubleshooting
Cloudy Water or Low-Chlorine Levels
• Shock the hot tub with FROG Maintain, a non-chlorine shock.
• Check water balance. pH and Total Alkalinity need to be in
the proper ranges for the FROG @ease System to work correctly.
• Check FROG @ease SmartChlor Cartridge and replace if
empty—see instructions under Step 3: Put the System to Work.
• If FROG @ease SmartChlor Cartridge is not empty, turn
dial setting up one number while maintaining water balance.
If needed turn dial up again.
• Check your calendar. The entire FROG @ease System including
a FROG @ease Mineral Cartridge needs to be replaced every
four months. Without the minerals, SmartChlor will not be
enough to sanitize the hot tub.
FROG @ease SmartChlor Cartridge Life
• If hot tub is larger than 400 gallons with significant bather load, you
Learn more at frogproducts.com or call 800.222.0169
Register your FROG @ease Sanitizing System at frogproducts.com
may require a higher dial setting which will shorten the cartridge life.
• If you think the cartridge setting is too high, you can turn the
dial setting down one number while maintaining water balance.
If needed, turn dial down again.
High Chlorine Levels
• This is highly unlikely with the FROG @ease System because
SmartChlor is self-regulating. However, if you use standard
test strips, it may appear that total chlorine is higher than the
free chlorine.
• No worries—the strip is measuring the SmartChlor reserve,
which will shift to free chlorine as needed. Please always use
the FROG @ease Test Strips that were included with your
System.
+ FROG @ease System consists of the FROG minerals silver chloride and carbonate
used with 0.5 ppm of FROG @ease SmartChlor Cartridge.
The FROG @ease Mineral
Cartridge must be used in conjunction with the FROG @ease SmartChlor Cartridge.
* Compared to the minimum ANSI recommended chlorine level of 2.0 ppm for a
hot tub.
For pools and hot tubs.
EPA Est. No.: 64114-MN-1 E09220723R5
20-48-0108
4 56
Step 4: Routine Hot Tub Care
1.
Drain and refill hot tub as direct-
ed by your hot tub manufacturer.
Whenever you drain and refill,
make sure to replace your FROG
@ease minerals.
2.
3.
4.
6.
Regularly test water with FROG
@ease Test Strips and follow
directions in Step 1 for main-
taining pH, Total Alkalinity and
Hardness.
NOTE: Why FROG @ease Test Strips? The FROG @ease Smart-
Chlor Cartridge forms a chlorine reserve that will be inaccurately
measured as total chlorine on other test strips. Unlike conventional
chlorine, the SmartChlor reserve readily shifts to free chlorine as
needed, maintaining hot tub health with a low level of chlorine.
FROG @ease SmartChlor Cartridge will maintain 0.5-1.0
ppm free chlorine level as long as the water is balanced.
NOTE: Free Chlorine levels are reduced up to 75%*
when using FROG @ease Minerals.
Follow the same procedure for the FROG @ease SmartChlor
Cartridge into the other opening.
Replace lter snap cap.
6.
FROG
@ease
Mineral
Cartridge
FROG
@ease
SmartChlor
Cartridge
With the silver FROG
@ease SmartChlor Cartridge
facing the inside of the hot
tub, insert cartridge holder
between the lter cartridges
under the weir door/ lter
plate pushing down until it
stays in place.
5.
7.
2.
1.
4.
3.
Replace your FROG @ease SmartChlor Cartridge and
complete FROG @ease System that comes with a FROG
@ease Mineral Cartridge as directed under “Step 3: Put
the System to Work”.
Run filtration system as
recommended by your hot
tub manufacturer to maintain
proper water flow through the
system.
Replacing Cartridges
Replace FROG @ease Mineral Cartridge every four months,
or when draining and refilling hot tub.
Discard it in the trash even though you will hear the spent media left
inside. Don’t attempt to reuse: the minerals are spent after 4 months.
Replace FROG @ease SmartChlor Cartridge when empty based
on the FROG @ease Test Strip showing a lighter color than the
out indicator on the bottle. The life of the cartridge varies depend-
ing on hot tub size and number of users. FROG @ease SmartChlor
Cartridge will last about 3-4 weeks for an average 400 gallon hot tub.
Drain water from cartridge to ensure it is empty. Discard in trash or
offer for recycling if available.
Using the Simplicty Filter System
Turn off main power
to the hot tub and
remove the JetPak to the
right of the main control.
Replace JetPak.
Made in U.S.A. Patents: kingtechnology.com/IP
Ver la versión en español de este manual en frogproducts.com
Manufactured for King Technology, Inc.
6000 Clearwater Dr, Minnetonka, MN 55343 U.S.A.
800-222-0169 | frogproducts.com
To remove
cartridges,
pull up at the
top of cartridge
and lift out.
Pull
Up
Simplicity
Filter
System
FROG @ease System
FROG @ease XL System
FROG @ease System
FROG @ease XL System
Pull
Up
To Previous Page
Loading...
