Attach the Mounting Bracket (G) to Mounting Bracket (F) using 4 Bolts and larger diameter Flat Washers (B).
Position Hose Housing over Mounting Bracket and lock into place using the Mounting Pin (E).
Connect the leader hose to water source.
Operating Instructions:
Pull out the hose to the desired length. Once stopped, the hose will automatically lock.
To unlock and retract the hose, pull out and let the hose retract automatically.
o WARNING: Always hold the hose until it completely retracts back to the reel.
Care and Maintenance:
Shut off the faucet after use and release water pressure.
It is recommended to store the hose reel indoors during periods of cold weather.
Use only mild soap and water if needed to clean the unit.
Troubleshooting:
FAQ: The hose will not retract automatically after fully extending.
Solution:
Hold the hose at the yellow warning mark and pull with a hard jerking motion until the hose retracts.
If the above does not work remove the Mounting Pin and remove the reel from the Mounting Bracket. Place the
reel with the right side down and pull from the yellow warning mark until the hose retracts.
Please contact one of our Product Specialists for assembly assistance or questions at 1-800-537-8484 or email
ps@frontgate.com. Specialists are available weekdays 8:00 a.m. to 8:00 p.m. EST or Saturday 9:30 a.m. to 6:00 p.m.
To Previous Page
Loading...