9
2
1 Base Shell 1
2 Base Lid 1
3 Steel Wrench 1
4
Inverted Base Stem 1
5
Inverted Plate 1
6 Playground Sand (not included) 200 lbs.
7 Rotating Hub 1
8 Large Hexagon Wrench 1
9
Main Frame and Rotating Hub 1
10
Crank Lift Handle 1
11 Small Hexagon Wrench 1
12 Hub Bolts 4
13
Plate Bolts 4
14 Washers 4
PARTS LIST
Part Description Qty.
REQUIRED FOR ASSEMBLY:
• 200 lbs. playground sand (not included).
NOTE:
Do not put or allow sand into the center of the base shell.
IMPORTANT:
Prior to assembly it is important to decide on the location of the
umbrella.
• Allow ample height to avoid damage to your umbrella during assembly and usage.
• Choose a location that is level and sturdy.
• Avoid any sloping or soft ground.
• Consider a location that will maximize the umbrella’s rotating swivel function. Placing
the umbrella between two entertaining areas is ideal.
NOTE:
Some parts may be included in the styrofoam packaging.
DO NOT discard any packaging or box until assembly is complete.
SAFETY PRECAUTIONS:
• Close the umbrella in windy conditions or when a storm approaches.
Never allow the umbrella to flap in the wind; this could damage the canopy.
• Do not leave open umbrella unattended. If damage occurs, this is not covered
by the warranty.
• When adjusting the umbrella, make sure that no person(s) or item(s) are close to
the umbrella. This is important to prevent injury or material damage.
CARE AND MAINTENANCE:
• When not in use, close and cover umbrella with a protective cover.
• Allow a wet canopy to dry opened up.
• If necessary, clean the fabric with lukewarm water, mild detergent, and a sponge.
• Wipe sliding marks on the aluminum poles with a damp cloth.
Winter Storage:
• Store in a dry place.
• Any visible defects must be repaired by a professional.
After the Winter:
• Areas subject to turning and sliding can be treated with a non-staining lubricant
spray (silicone-based).
• Check the condition and function of the umbrella. Any defects must be repaired by
a professional.
To Next Page
Loading...
