A - Base Shell and Base Lid G - Double Wind Vent Canopy
B - Collar Base Stem H - Removable Crank Handle
C - Main Frame I - Socket A - To extend and retract arm
D - Arm Connector J - Socket B - To open and close canopy
E - Inner Frame Arm K - Release Knob
F - Gemel Hinge L - Crank Handle Storage
REQUIRED FOR ASSEMBLY:
• 200 lbs. all purpose sand (not included).
NOTE: Avoid allowing sand into the center section of the base shell.
11ft. European Side Mount Umbrella
Item # 68286A
Thank you for purchasing Frontgate’s European Cantilever umbrella. Please
remove all contents from the package and inspect all parts.
CAUTION: To reduce personal injury and damage to your umbrella, read and
follow this Assembly and Operation information.
CHECK LIST:
SAFETY PRECAUTIONS:
• Close the umbrella in windy conditions or when a storm approaches.
Never allow the umbrella to flap in the wind; this could damage the canopy.
• Do not leave open umbrella unattended. If damage occurs, this is not covered
by the warranty.
• When adjusting the umbrella, make sure that no person(s) or item(s) are close to
the umbrella. This is important to prevent injury or material damage.
CARE AND MAINTENANCE:
• When not in use, close and cover umbrella with a protective cover.
• Allow a wet canopy to dry opened up.
• If necessary, clean the fabric with lukewarm water, mild detergent, and a sponge.
• Wipe sliding marks on the aluminum poles with a damp cloth.
Winter Storage:
• Store in a dry place.
After the Winter:
• Check the condition and function of the umbrella. Any defects must be repaired by
a professional.
To Next Page
Loading...
