standard wall outlet, switch the on/off switch to ON. The transmitter's GREEN led will light
up.
2. To switch on the speaker, press the POWER button 3sec on the front panel of the speaker.
The GREEN led illuminates.
3. Turn on the audio source the transmitter is turned off for less then 4 minutes, the blue LEDs
on the transmitter and the speaker illuminate when the audio signal link between the two is
made.
4. If the audio source connected to the transmitter is turned off for less than 4 minutes, the
BLUE leds on the transmitter and the speaker remain on, but no sound is transmitted.
When the audio signal returns to the transmitter, sound is transmitted again.
5. If no signal is detected for more than 4 minutes, the transmitter automatically turns off ; the
BLUE leds on the transmitter and the speaker switch to GREEN.
6. If no signal is detected from the transmitter for more than 5 minutes, the speaker
automatically shifts to Standby mode.
7. If no audio signal is detected from the transmitter for more than 15 minutes, the speaker
automatically turns off. The GREEN led goes off.
8. To switch on the speaker, press the POWER button 3sec on the front panel of the speaker.
9. To switch off the speaker. Press the POWER button 3sec again.
PAIRING
1. If there is no audio sound is detected after connecting is done, re-pairing processes is
required.
2. Press the “PAIR” buttons on both transmitter and speakers Mood light /Pair button for 5
seconds, there will have a “Do” sound detected when the pairing process is finished.
Mood Light
For mood light effect, press the LIGHTS button on the speaker or remote control.
Left / Right Channel and Mono Selection
The Wireless Outdoor Speaker System comes with one speaker and is designed for either Mono or
Stereo playback. For stereo playback, an additional speaker must be purchased separately. Mono
playback is suggested when only one speaker is used in an area or room.
Mono Playback
To enable Mono playback, ensure that the switch located on the back panel of the speaker is in the
MONO position.
Stereo Playback
To enable Stereo playback, set the switch on one of the two speakers' back panel to LEFT. Set the
switch on the other speaker to RIGHT.
To Next Page
Loading...