Wall mounting
screw set
Power supply
AC cable
Aux-in cord
1 meter micro
USB cable
Lithium Ion
Battery
Phillips head
screwdriver
1. Check the contents of your Juno system box against the parts listed below
4 meter USB cable
ITM-01 Pendant
Microphone
1. Unscrew battery door on the back of the micro-
phone using the supplied Phillips screwdriver.
2. Locate the charge contacts on the battery and on
the microphone. See Image 1
3. Insert battery into compartment - battery contacts
first, then push the battery into place.
See Image 2
4. Replace battery door.
Charging microphone
Connect the USB cable to one of the Juno Tower’s
charge ports and the other end to the charge port
on the microphone. See Image 3
NOTE: For best performance, charge battery
overnight before initial use.
Image 2
Image 1
2. Install ITM-01 Teacher Pendant Microphone battery
ITR-01 Juno Tower
Amplifier / Receiver
Juno System Quick Setup Guide
1. Place microphone around neck and connect clasp.
2. Adjust neck straps to position microphone approx-
imately 5in (14cm) from mouth. See Image 1
3. Press One-Touch button to wake microphone. Power
indicator should be green. See Image 2
NOTE: Your microphone will go into standby mode
(off) automatically after 10 minutes in mute mode or
10 minutes of silence. Press One-Touch button to wake.
4. Momentarily press One-Touch button to mute as
needed for private conversations. Mute indicator
light will turn red. See Image 2
5. Press and hold One-Touch button to issue a voice
command.
6. When the battery in your microphone gets low, the
battery indicator will flash red. See Image 2
Image 1
Image 2
3. Using ITM-01 Teacher Pendant Microphone battery
Remember to put your microphone in the charger stand at the end of the day.
Image 3
Moisture
indicator
Charge
contacts
One-Touch
button
battery
indicator
power indicator
mute
indicator
5in/14cm
To Next Page
Need help?
General
