FTR CaddyTrek - Folding CaddyTrek for Transport or Storage

Folding CaddyTrek for Transport or Storage
Folding CaddyTrek is easy after you’ve practiced a few times. Refer to the setup photos and follow in reverse
order:
Make sure CaddyTrek is placed on leveled ground and is powered off.
Loosen the two black knobs on the Upper Bag Support Bar, lower the handle, and tighten the two black
knobs.
Fold in the 5th wheel (pull wheel arm to the left then slide the wheel under the Battery Housing case).
Loosen the two yellow knobs on the lower frame. Release the yellow flap (lock) on the Frame Lock in the
middle.
Step on the 5th wheel bracket. Use one hand to grab the Small Wheel Bar and push it inward, while your
other hand grabs the Upper Bag Support Bar and lowers it over the Small Wheels Bar. Make sure the caddy
is tucked in tightly and securely. Refer to the user manual for complete details (reverse steps of the unfolding
instructions shown on the opposite side of this card).
Tighten the two yellow knobs.
CaddyTrek is now ready to be picked up by the Handle and stored away.