Need help?Do you have a question about the FTS DigiTemp and is the answer not in the manual?
Provides an overview of the DigiTemp sensor's capabilities, design, and operating principles.
Details the steps and considerations for physically installing the DigiTemp sensor in its intended environment.
Explains how to connect the DigiTemp sensor, including wire color coding and connector pinouts.
Describes how the DigiTemp sensor functions, powered by the SDI-12 bus, and how it communicates.
Covers the sensor's configuration, primarily its SDI-12 address, and how to change it if needed.
Outlines calibration requirements (none needed) and basic maintenance procedures for the sensor.
Explains the syntax, format, and text representation used for SDI commands and device replies.
Lists and briefly describes the specific SDI commands that the DigiTemp sensor understands and responds to.
Details general housekeeping commands for device address configuration, identification, and communication.
Describes commands used to initiate measurements and retrieve data from the sensor.
Defines the measured values provided by the sensor, including units and measurement resolution.
General| Measurement Range | -50°C to 300°C (-58°F to 572°F) |
|---|---|
| Display | LCD |
| Resolution | 0.1°C (0.1°F) |
| Probe Type | Stainless steel |
| Weight | 50 g |
To Next Page