Fu Sheng Co FR005AP - User Manual

Questions and Answers

J
Joseph HarrisJul 31, 2025
What to do if my Fu Sheng Co Dryer machine stops suddenly during operation?
- A
  Allen BeasleyJul 31, 2025
  If your Fu Sheng Co dryer suddenly stops, there could be several reasons: * A faulty magnetic contactor: Consider replacing it. * The air processing rate might be too high: Correct the air processing rate. * The condenser might be clogged: Clean it. * The ambient temperature might be too high: Lower the ambient temperature (below 40 ?). * There might be abnormal voltage: Use the rated voltage. * A faulty fan control pressure switch: Replace it.
J
James RamirezAug 6, 2025
Why is the dew point high and water or oil drops occurring in my Fu Sheng Co Dryer?
- R
  richardhodgesAug 6, 2025
  If you're experiencing a high dew point along with water or oil drops in your Fu Sheng Co Dryer, the causes could be: * The air processing rate is too high: Correct the air processing rate. * Lowered cooling capacity: Check for gas leaks. * A clogged condenser: Clean it. * The ambient temperature is too high: Lower the ambient temperature (below 40 ?). * The fan motor is faulty: Replace it.
C
carrie87Aug 13, 2025
What to do if my Fu Sheng Co FR005AP does not operate when the operation switch is ON and the RUN lamp does not light up?
- P
  philip41Aug 13, 2025
  If your Fu Sheng Co dryer isn't starting and the RUN lamp remains off, check these potential causes: * The lamp may be disconnected: Replace it. * The switch may be faulty: Replace it. * The power supply voltage may be low: Use the specified voltage. * The magnetic contactor may be faulty: Replace it. * The protector may be faulty: Replace it. * The high-pressure switch may be faulty: Replace it.
D
delgadojamesAug 18, 2025
What to do if my Fu Sheng Co FR005AP Dryer does not operate when the operation switch is ON and the RUN lamp lights up?
- J
  Jason WagnerAug 18, 2025
  If your Fu Sheng Co dryer isn't starting, but the RUN lamp is on, consider these potential issues: * The magnetic contactor may be faulty: Replace it. * The protector may be faulty: Replace it.
M
Michelle CooperAug 25, 2025
What to do if the dew point is normal but water or oil drops occur in my Fu Sheng Co FR005AP?
- D
  damon44Aug 25, 2025
  If you're experiencing water or oil drops despite a normal dew point in your Fu Sheng Co Dryer, it could be due to: * Drainage hindered by foreign material in the auto drain trap: Disassemble and clean the auto drain trap. * Drainage in the auto drain trap frozen: Take proper measures to prevent freezing.