FUEGO
ACTIVE NOISE CANCELLING
WIRELESS EARBUDS
OVERVIEW OPERATION
Thank you for purchasing the Fuego Active Noise Cancelling Wireless
Earbuds. Please read these instructions carefully for proper operation
and save for future reference.
Turning ON/OFF
Power on: Hold the MULTIFUNCTION (MF) button for
3 seconds until the LED ashes blue.
Power off: Hold the MF button for 4 seconds until the
LED turns red then turns off.
Connecting with Bluetooth
To play audio from a Bluetooth device,
you need to pair the device with your earbuds.
1. With the earbuds turned off, hold the MF button for
6-8 seconds to enter pairing mode, indicated by
the voice prompt “Pairing”. The LED ashes blue
and red, indicating the earbuds are ready to
connect with your Bluetooth device.
2. Turn on Bluetooth mode on your device.
3. Select “Santana Fuego” to initiate pairing, and the
earbuds will automatically connect with your
Bluetooth device, indicated by a blue light and
voice prompt “Connected”. Some devices ask you
to input the PIN “0000” as the password.
Note: Generally, there is a 5 minute maximum to pair
the earbuds with your Bluetooth device, otherwise
retry steps 1 to 3 to pair again.
MULTIFUNCTION (MF) Button
VOL(+) Button
VOL(–) Button
MF Button
• Power On/O
• Play
• Pause
• Answer/End Calls
Voice Isolating
Microphone
(opposite side)
Aircraft Aluminum Earbud
Casings
Stabilizing Wing Tips
Magnetic Ends
ANC Button
Active Noise Cancellation
On/O
(opposite side)
• Volume –
• Repeat Track
• Volume +
• Skip Track
Charging Port
To Next Page
General