Paper Jams
553
Problem Solving
15
When HCF (A4 2 Tray) is NOT Installed
1
Open the Tray 5 (Bypass) top cover.
2 Remove all paper loaded in Tray 5 (Bypass).
Important • When two or more sheets of paper are
loaded, remove all of the sheets from the
tray.
Note • If paper is torn, check for any torn pieces of
paper inside the machine.
3 Close the top cover.
4 Fan the paper you removed making sure that all four corners are neatly aligned.
5 Insert the paper into tray with the printing side
facing up until its edge lightly touches against
the paper feed entrance.
Note • Do not load paper above the maximum fill
line. It might cause paper jams or machine
malfunctions.
When HCF (A4 2 Tray) is Installed
1
Remove all paper loaded in Tray 5 (Bypass).
Important • When two or more sheets of paper are
loaded, remove all of the sheets from the
tray.
Note • If paper is torn, check for any torn pieces of
paper inside the machine.
2 Fan the paper you removed making sure that all four corners are neatly aligned.
To Next Page
Loading...
