Fuji Xerox ApeosPort-VII CP4421 User Manual

[Connectivity & Network Setup]
147
 [TBCP]
Select this when the output protocol of the print driver is in the TBCP format.
 [RAW]
Select this when the output protocol of the print driver is in the ASCII or binary format.
The data is printed without being controlled by the Adobe
®
communication protocol.
[LPD]
 [Port Status]
Select [Enabled] to use LPD.
 [Port Number]
Enter a port number for LPD.
Important

Do not use the numbers assigned to the other ports.
 [Maximum Number of Sessions]
Enter the maximum number of client sessions using LPD.
[IPP]
 [Port Status]
Select [Enabled] to use IPP.
Set this when you want to use IPP (Internet Printing Protocol) to print via the Internet.
 [Added Port Number]
Set whether or not to accept IPP from other than the standard port number.
Important

Do not use a number that is the same as a port number of another port. However, you can use the same port
number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP, and Web Services on
Devices (WSD)).
Note

[Added Port Number] cannot be configured if [Port Status] is set to [Disabled]. To configure [Added Port
Number], enable port status and reboot the device, and then configure [Added Port Number].
[Bonjour]
 [Port Status]
Select [Enabled] to use Bonjour.
Note

To print from a printer detected by [Bonjour], the LPD port must be activated in advance.
[Port 9100]
 [Port Status]
Select [Enabled] to use Port 9100.
Select this option when the communication protocol is in the RAW format for Windows
Standard TCP/IP port monitor.

Fuji Xerox ApeosPort-VII CP4421 Specifications

General

Brand	Fuji Xerox
Model	ApeosPort-VII CP4421
Category	Printer
Language	English