Fuji Xerox ApeosPort-VII CP4421 User Manual

[Connectivity & Network Setup]
161

[Preshared Key]
Enter a preshared key.
This setting is valid when [IKE Authentication Method] is set to [Authenticate by
Preshared Key].

[Device Certificate]
Select a certificate for IPsec communications.
Select a certificate when [IKE Authentication Method] is set to [Authenticate by Digital
Signature]. A self-signed certificate created by CentreWare Internet Services cannot be
used.
Reference

For more information on a certificate, refer to "Types of Certificate" (P.180).

[IPsec Communication]
Select whether or not to enable IPsec communications.

[IKE SA Lifetime]
Specify IKE SA lifetime.
Note

The value must be greater than the value set in [IPsec SA Lifetime].

[IPsec SA Lifetime]
Specify IPsec SA lifetime.
Note

The value must be smaller than the value set in [IKE SA Lifetime].

[DH Group]
Set DH group.

[PFS Settings]
Select whether or not to enable PFS.

[Destination IPv4 Address]
Set the IPv4 address or area of the destination permitted to communicate.

[Destination IPv6 Address]
Set the IPv6 address or area of the destination permitted to communicate.

[Communicate with Non-IPsec Devices]
Select whether or not to communicate with non-IPsec devices with an address other than
the ones set in the destination address.
[IEEE 802.1X Settings]
 [IEEE 802.1X Settings] / [IEEE 802.1X Settings (Ethernet 1)]

[IEEE 802.1X]
Set whether or not to use IEEE 802.1X authentication.

[Authentication Method]
Set the authentication method for IEEE 802.1x.

[Login User Name]
Enter the login user name with up to 128 characters.

Fuji Xerox ApeosPort-VII CP4421 Specifications

General

Brand	Fuji Xerox
Model	ApeosPort-VII CP4421
Category	Printer
Language	English