Paper Types
55
Paper and Other Media
2
*1 : Select the paper type setting for the paper loaded on a tray. For more information, refer to "Changing the Paper Settings"
(P.72).
*2 : Most ideal image quality with the paper can be obtained by setting the image quality for each type of paper. For more
information on the settings, refer to "Image Quality" (P.170).
Note • For more information on special media such as other heavyweight paper, contact our Customer
Support Center.
Limited Paper
You can use the following paper with limitations:
P801 A4 Unknown Trans-
parency
-
The paper is charged with
static electricity after a copy or
print job.
When using Tray 5, insert
another type of paper at the
bottom of the stack before
loading transparencies.
Universal
Transparency Plain
115MIC
A4 Unknown Trans-
parency
-
If two or more sheets of
transparencies are being fed
simultaneously (double-feed),
load one sheet at a time.
V510 A4 Unknown Trans-
parency
-
Transfer deterioration might
be occurred when copying or
printing in color. Also, toner
may spatter on color images in
prints.
When using Tray 5, insert
another type of paper at the
bottom of the stack before
loading transparencies.
Paper Name Size
Basis Weight
(gsm)
Paper
Type
*1
Image
Quality
*2
Notes / Countermeasure
Paper Name Size
Basis Weight
(gsm)
Paper
Type
*1
Image
Quality
*2
Notes / Countermeasure
Colotech + A4 200 Extra-HW Extra-HW A
Load paper with the curl side
up in Tray 5.
Colotech + A3 200 Extra-HW Extra-HW A
Load paper with the curl side
up in Tray 5.
Colotech + A4 250 Extra-HW Extra-HW B
Images may be degraded.
Colotech + A3 250 Extra-HW Extra-HW B
Images may be degraded.
It is recommended to load
paper in portrait orientation. If
it is not possible, use Tray 5.
If paper jam occurs, use Tray 5.
Colotech + A4 280 X-HW Plus Extra-HW A
It is recommended to load
paper in portrait orientation. If
it is not possible, use Tray 5.
If paper jam occurs, use Tray 5.
Colotech + A3 280 X-HW Plus Extra-HW A
It is recommended to load
paper in portrait orientation. If
it is not possible, use Tray 5.
If paper jam occurs, use Tray 5.