Copying Procedure
103
Copy
3
Important • To avoid paper jams, use the document glass for folded or wrinkled documents, cut-and-pasted
documents, curled paper, or back carbon paper.
• When Duplex Automatic Document Feeder B1-C is installed, the lightweight paper of 38 - 49 gsm
cannot be scanned 2 sided.
For information on how to copy mixed sized documents, refer to "Mixed Size Originals (Scanning Different Size Documents
Simultaneously)" (P.139).
1 Remove any paper clips and staples before loading a document.
2 Load the document face up (when the
document is 2-sided, load the front side up) in
the center of the document feeder.
Note • The Confirmation indicator lights up when
the document is loaded correctly. If the
indicator does not light, load the document
again.
3 Adjust the document guides to match the size
of the document loaded.
4 Pull out the document stopper.
Document Glass
The document glass supports a single sheet, a book, or other similar documents with size 297
x 432 mm (Standard size: A3, 11 x 17").
Important • Always close the document cover after using the document glass.
The document glass automatically detects standard size documents. For non-standard size
documents, enter the size on the [Original Size] screen.
For information on document sizes that can be detected automatically and how to enter a non-standard document size,
refer to "Original Size (Specifying the Scan Size for the Document)" (P.138).
Heavyweight paper (81 - 128 gsm) 75 sheets 85 sheets
Document Type (Weight)
Number of Sheets
Duplex Automatic
Document Feeder
B1-C
Duplex Automatic
Document Feeder
B1-PC
To Next Page
Loading...
Need help?
General
