Appendix
774
Appendix
16
3
Select the tray in which you loaded paper, and press the <Start> button.
The sample is printed.
4
Select [Close].
5
Check the printed sample printout, and measure the A and B fold position movement
amounts.
6
Enter the value you measured in step 5 in [Values A & B Before Adjustment], and the value
to which to adjust in [Desired Values A & B].
z
Set value B so that an edge of the paper does not extend beyond a fold position of the paper. Extending an
edge of paper beyond a fold position of the paper may cause a paper jam.
7
Select [Adjust].
8
Select [Sample Printout] again.
9
Select the tray in which you loaded paper, and press the <Start> button.The sample is
printed.
10
Select [Close].
11
Confirm the result of sample printout.
12
Adjust the alignment again if necessary. (Step 5 to 11)
13
Select [Save].
To Next Page
Loading...
