Unpack the machine and check the components
Read the Safety Guide first, then read this Quick Setup Guide for the correct installation
procedure.
NOTE:
• The components included in the box and the AC power plug may differ depending on your
country.
• The available connection interfaces vary depending on the model.
• The illustrations in this Quick Setup Guide are based on the DocuPrint P265 dw.
• The USB cable is a standard accessory.
Network cable
Use a straight-through Category 5 (or greater) twisted-pair cable for 10BASE-T or
100BASE-TX Fast Ethernet Network.
Remove the packing materials and install the toner cartridge
Load paper in the paper tray
Connect the machine to your computer/mobile device
Connect the power cord and turn on the machine
Select your language (Only for certain models)
A
Drum Unit
(Pre-installed)
AC Power Cord
(only for certain models)
Quick Setup Guide
B
USB Interface Cable Inbox/Starter Toner
Cartridge
CD‑ROM Safety Guide
1. Press ▼ or ▲ to select General Setup, and then press OK.
2. Press OK to select Local Language.
3. Press ▼ or ▲ to select your language, and then press OK.
A
B
B
A
A
B
3
4
2
5
1
Adjust the paper guides.
• Windows
®
PC with a CD-ROM drive, go to step 5A
• Windows
®
PC without a CD-ROM drive, go to step 5B
• Macintosh, go to step 5B
• Mobile device users with a WPS/AOSS-supported access point/router, go to step 5C
Back Front
Remove the orange part. Remove the orange part.
Quick Setup Guide
DocuPrint P225 d / DocuPrint P265 dw
LJB476001-00
604E 77060 MB3547E2-1 (Edition 1)
September 2014
Copyright © 2014 by Fuji Xerox Co., Ltd.
Fuji Xerox Co., Ltd. Printed in Vietnam
To Next Page
Need help?
General
