284
WLAN TCP/IP Boot Method Choose the IP method that best suits your needs.
IP Address Enter the IP address.
Subnet Mask Enter the Subnet mask.
Gateway Enter the Gateway address.
IP Boot Tries Specify the number of attempts the machine will try to
obtain an IP address when the Boot Method is set to
any setting except Static.
APIPA Allocate the IP address from the link-local address
range automatically
*1
.
IPv6 Enable or disable the IPv6 protocol.
Setup Wizard - Configure the wireless network settings using the
setup wizard.
WLAN Assistant - Configure your wireless network settings using the Fuji
Xerox installation disc.
WPS - Configure your wireless network settings using the
one-button push method.
WPS w/PIN Code - Configure the wireless network settings using WPS
with a PIN code.
WLAN Status Status Display the wireless Ethernet link status.
Signal Display the signal condition.
Channel Display the channel in use when Status is Active.
Speed Display the connection speed when Status is
Active.
SSID Display SSID.
Comm. Mode Display the current Communication Mode.
MAC Address - Display the MAC address of the machine.
Set to Default - Restore wireless network settings of your machine to
the factory settings.
WLAN Enable - Turn the wireless interface on or off.
Level 1 Level 2 Level 3 Description
To Next Page
Loading...
Need help?
General
