Fujiair NF166 - Wireless Remote Controller Operation; Power and Sleep Functions; Timer and Time Setting; Mode and Speed Control

INSTALLATION AND USER MANUAL
WIRELESS REMOTE CONTROLLER AND ITS OPERATING FUNCTIONS
NF166
MODE : Operation selection AUTO or
COOL or DRY or FAN.
SLEEP : Press ON/OFF to allow 2 ℃
℃℃
℃
increase from Set-Temperature.
After each 1 hour will increase by 1 ℃
℃℃
℃ ;up
to 2hours by total of 2 ℃
℃℃
℃
TIMER ：
：：
： To switch off automatically
after setting timer off between
1~9 hours from press of button.
POWER : To turn On/Off the
air-conditioner,press to On,
next to OFF,and so on.
TEMP : To allow adjust of Set-
Temperature by 1 ℃
℃℃
℃ up or
down between 16 to 32 ℃
℃℃
℃ .
TIME : To allow adjust of real time
or on/off timer.
SPEED : To set air flow to 4
different setting by each
press of button
【
【【
【 AUTO 】→【
】→【】→【
】→【 】→【
】→【】→【
】→【 】→【
】→【】→【
】→【 】
】】
】
→【
→【→【
→【 AUTO 】
】】
】
Difference between
Room and Set-Temp
Above 3 ℃
℃℃
℃
2~3 ℃
℃℃
℃
HIGH
MEDIUM
LOW
AUTO
Speed
Below 2 ℃
℃℃
℃
DIREC. : To adjust to swing and fix
position of air flap.Press to
stop swing to fix position.
AUTO : Auto to adjust position
of air flap.Press to swing
auto.
OFF : To set off timer.
When press to set off timer,
the off timer will flash. .Then can
adjust the off timer.
ON : To set on timer.
When press to set on timer,
the on timer will flash.Then
can adjust the on timer.
ENT. : To enter on/off timer.
When on/off timer flash,
press to enter on/off
timer.
DEL. : To cancel on/off timer.
When on/off timer flash,press to
cancel on/off timer.
CLOCK : To set real time.
When press to set real time,
the real timer will flash.Then
can adjust the real time.
ACL : To reset the remote control.
REMOTE SENSOR FUNCTIONS
Hole to receive output signal from wireless Remote Controller.
LED Light indications:OFF Status:LED not lighted up
ON Status:Compressor OFF-Blinking
Compressor ON-LED lighted