EN-7ENGLISH
Changes and Additions
RED EYE REMOVAL
Remove red-eye e ects caused by the ash.
Option
Description
FLASH +
REMOVAL
A red-eye reduction pre- ash is combined with
digital red-eye removal.
FLASH Flash red-eye reduction only.
REMOVAL Digital red-eye removal only.
OFF
Flash red-eye reduction and digital red-eye
removal o .
R Flash red-eye reduction is not available in TTL ash control
mode or while TTL lock is in e ect. Digital red-eye removal
is performed only when a face is detected and is not avail-
able with RAW images.
TTL-LOCK MODE
Instead of adjusting ash level with each shot, TTL ash
control can be locked for consistent results across a se-
ries of photographs.
Option
Description
LOCK WITH LAST
FLASH
The value metered for the most recent photo
taken using TTL will be used for subsequent
photos. An error message will be displayed if
no previously metered value exists.
LOCK WITH
METERING FLASH
The value metered with the next series of pre-
ashes will be used for subsequent photos.
R To use TTL lock, assign TTL-LOCK to a camera control and
then use the control to enable or disable TTL lock.
R Flash compensation can be adjusted while TTL lock is in
e ect. TTL lock can not be combined with ash red-eye
reduction.
To Next Page
Loading...
