FujiFilm X-Pro 2 - Page 8

EN-6 ENGLISH
Changes and Additions
G
Flash mode (TTL): Choose a  ash mode for TTL  ash control.
• FLASH AUTO: The  ash  res only as required;  ash level is
adjusted according to subject brightness. A p icon
displayed when the shutter button is pressed halfway
indicates that the  ash will  re when the photo is taken.
• STANDARD: The  ash  res with every shot if possible;  ash
level is adjusted according to subject brightness. The
 ash will not  re if not fully charged when the shutter
is released.
• SLOW SYNC.: Combine the  ash with slow shutter speeds
when photographing portrait subjects against a back-
drop of night scenery. The  ash will not  re if not fully
charged when the shutter is released.
H
Sync: Control  ash timing.
• 1ST CURTAIN: The  ash  res immediately after the shutter
opens (generally the best choice).
• 2ND CURTAIN: The  ash  res immediately before the shut-
ter closes.
• AUTO FP(HSS): High-speed sync (compatible units only).
The camera automatically engages front-curtain high-
speed sync at shutter speeds faster than the  ash sync
speed. Equivalent to 1ST CURTAIN when MULTI is selected
for  ash control mode.
I
Zoom: The angle of illumination ( ash coverage) for units
that support  ash zoom. Some units allow the adjustment
to be made from the camera. If AUTO is selected, zoom will
automatically be adjusted to match coverage to lens focal
length.
J
Lighting: If the unit supports this feature, choose from the
options below.
• FLASH POWER PRIORITY: Gain range by slightly reducing
coverage.
• STANDARD: Match coverage to picture angle.
• EVEN COVERAGE PRIORITY: Slightly increase coverage for
more even lighting.
K
Master: Assign the master  ash to group A (Gr A), B (Gr B),
or C (Gr C). If OFF is selected, output from the master  ash
will be held to a level that does not a ect the  nal picture.
Available only if the unit is mounted on the camera hot
shoe as a master  ash for FUJIFILM optical wireless remote
 ash control in TTL, TTL%, or M mode.
K
Number of  ashes: Choose the number of times the  ash
 res each time the shutter is released in MULTI mode.
L
Channel: Choose the channel used by the master  ash for
communication with the remote  ash units. Separate
channels can be used for di erent  ash systems or to pre-
vent interference when multiple systems are operating in
close proximity.
L
Frequency: Choose the frequency at which the  ash  res
in MULTI mode.