FujiFilm X-Pro 2 - Page 7

EN-5ENGLISH
Changes and Additions
■ MASTER (OPTICAL)
The options at right will be
displayed if the unit is cur-
rently functioning as master
 ash for FUJIFILM optical
wireless remote  ash control.
MODE
MASTER(OPTICAL)
ADJUST END
The master and remote units
can be placed in up to three
groups (A, B, and C) and  ash
mode and  ash level adjust-
ed separately for each group.
Four channels are available
for communication between
the units; separate channels can be used for di erent
 ash systems or to prevent interference when multiple
systems are operating in close proximity.
A
Flash control mode (group A)/
B
Flash control mode (group B)/
C
Flash control mode (group C): Choose  ash control modes
for groups A, B, and C. TTL% is available for groups A and
B only.
• TTL: The units in the group  re in TTL mode. Flash com-
pensation can be adjusted separately for each group.
• TTL%: If TTL% is selected for either group A or B, you can
specify the output of the selected group as a percentage
of the other and adjust overall  ash compensation for
both groups.
• M: In mode M, the units in the group  re at the selected
output (expressed as a fraction of full power) regardless
of subject brightness or camera settings.
• MULTI: Choosing MULTI for any group sets all the units in
all groups to repeating  ash mode. All units will  re mul-
tiple times with each shot.
• OFF: If OFF is selected, the units in the group will not  re.
D
Flash compensation/output (group A)/
E
Flash compensation/
output (group B)/
F
Flash compensation/output (group C): Ad-
just  ash level for the selected group according to option
selected for  ash control mode. Note that the full value
may not be applied if the limits of the  ash control system
are exceeded.
• TTL: Adjust  ash compensation.
• M/MULTI: Adjust  ash output.
• TTL%: Choose the balance between groups A and B and
adjust overall  ash compensation.
B
BB
A
C