FujiFilm X-Pro 2 - Page 6

EN-4 ENGLISH
Changes and Additions
C
Flash mode (TTL): Choose a  ash mode for TTL  ash control.
• FLASH AUTO: The  ash  res only as required;  ash level is
adjusted according to subject brightness. A p icon
displayed when the shutter button is pressed halfway
indicates that the  ash will  re when the photo is taken.
• STANDARD: The  ash  res with every shot if possible;  ash
level is adjusted according to subject brightness. The
 ash will not  re if not fully charged when the shutter
is released.
• SLOW SYNC.: Combine the  ash with slow shutter speeds
when photographing portrait subjects against a back-
drop of night scenery. The  ash will not  re if not fully
charged when the shutter is released.
D
Sync: Control  ash timing.
• 1ST CURTAIN: The  ash  res immediately after the shutter
opens (generally the best choice).
• 2ND CURTAIN: The  ash  res immediately before the shut-
ter closes.
• AUTO FP(HSS): High-speed sync (compatible units only).
The camera automatically engages front-curtain high-
speed sync at shutter speeds faster than the  ash sync
speed. Equivalent to 1ST CURTAIN when MULTI is selected
for  ash control mode.
E
Zoom: The angle of illumination ( ash coverage) for units
that support  ash zoom. Some units allow the adjust-
ment to be made from the camera. If AUTO is selected,
zoom will automatically be adjusted to match coverage
to lens focal length.
F
Lighting: If the unit supports this feature, choose from the
options below.
• FLASH POWER PRIORITY: Gain range by slightly reducing
coverage.
• STANDARD: Match coverage to picture angle.
• EVEN COVERAGE PRIORITY: Slightly increase coverage for
more even lighting.
G
LED light: Choose how the built-in LED light functions dur-
ing still photography (compatible units only). It can func-
tion as a catchlight (CATCHLIGHT), as an AF-assist illuminator
(AF ASSIST), or as both a catchlight and an AF-ASSIST illu-
minator (AF ASSIST+CATCHLIGHT). Choose OFF to disable the
LED during photography.
G
Number of  ashes: Choose the number of times the  ash
 res each time the shutter is released in MULTI mode.
*
H
Frequency: Choose the frequency at which the  ash  res in
MULTI mode.
*
* Full value may not be applied if limits of  ash control system are
exceeded.