7. Press the
button once to transmit the function setting information. 1 short beep will be emit-
ted from the indoor unit or the IR receiver when the signal is received correctly. If wrong code is
set, no beep sound will be emitted.
NOTE:
Press
button within 30 seconds after pressing MODE button.
For the function details, refer to Chapter 1-5. "Function details" on page 05-38.
8. Exit the function setting mode by pressing the RESET button.
1-2. Indoor unit (setting by wireless remote controller) - (05-17) - 1. Function settings (for indoor unit)
FIELD
WORKING
FIELD
WORKING