Setting Up the Weekly Timer Operation
Press the START/STOP button to stop the air conditioner, and
then proceed as follows.
1. Press the TIMER MODE button so that "WEEKLY"
appears on the display.
The display now shows the current day (by DAY CODE), the
first ON and OFF times for the day (the "WEEKLY 1" times),
the fan speed, and the operating mode.
The top time value gives the ON time, and the bottom value
gives the OFF time.
If either time is not set, the corresponding time display is
blank " " .
2. Press the SET TEMP./DAY button to select the day that
you want to set up.
▲ : Use to advance the day forward.
▼ : Use to turn the day back.
3. Hold the SET button down for 3 seconds.
The "WEEKLY 1" ON time starts flashing, and the fan speed
and operating mode displays go off.
4. Press the SET TIME button to set the day's first ON time.
▲ : Use to advance the day forward.
▼ : Use to turn the day back.
(Press once to move the time 5 minutes; hold down and the
time will move 10 minutes at a time.)
5. Press the SET button.
This registers the first ON time setting for the selected day.
The ON time display stops flashing, and the "WEEKLY 1"
OFF time starts flashing.
6. Press the SET TIME button to set the day's first OFF time.
The earliest OFF time you can set is 5 minutes after the ON
time. The latest OFF time is 23:55 on the subsequent day.
7. Press the SET button.
This registers the first OFF time for the day, completing the
"WEEKLY 1" settings for that day.
The display switches to "WEEKLY 2", and the day's second
ON time begins flashing.
8.
Repeat the operations described in Steps 4 to 7 to set the sec-
ond ON and OFF times for the day (the "WEEKLY 2" times).
When you press the SET button after setting the "WEEKLY 2"
OFF time, the system registers the "WEEKLY 2" settings for
the day and returns you to the "WEEKLY 1" ON time setup
process. (The first ON setting reappears and begins flashing.)
You can review your settings by pressing the SET button.
Each press moves you to the next setting, as follows.
DAY CODE
DAY OF THE WEEK
1
MON
2
TUE
3
WED
4
THU
5
FRI
6
SAT
7
SUN
If the timer is not set, press
the SET button with the
time display blank " ",
and perform next operation.
WEEKLY 1
ON
WEEKLY 1
OFF
WEEKLY 2
ON
WEEKLY 2
OFF
MASTER
CONTROL
FAN
CONTROL
TIMER
MODE
TEMP./DAY
SET TIME
CLOCK ADJUST
START/STOP
SET
DAY OFF
ZONE
ENERGY SAVE
COOL
OFF
ON
DAY
TIMER
WEEKLY
1 2
MASTER
CONTROL
FAN
CONTROL
TIMER
MODE
TEMP./DAY
SET TIME
CLOCK ADJUST
START/STOP
SET
DAY OFF
ZONE
ENERGY SAVE
OFF
ON
DAY
TIMER
WEEKLY
1
MASTER
CONTROL
FAN
CONTROL
TIMER
MODE
TEMP./DAY
SET TIME
CLOCK ADJUST
START/STOP
SET
DAY OFF
ZONE
ENERGY SAVE
OFF
ON
DAY
TIMER
WEEKLY
1
– 60 –
1
2
3
4
5
6
7
To Next Page
Loading...
Need help?
General
