Fujitsu ARXG14KLLAP Design & Technical Manual


Function setting procedure
1. Connect the power supply of the outdoor unit.
2. To enter the function setting mode, while holding down the POWERFUL and TEMP.
button,
press the RESET button.
POWERFUL
TEMP.
( )
RESET
Function setting
mode display
3. Select the function number by pressing the or the buttons. Each time the 10 °C HEAT
button is pressed, it switches between the right digit and the left digit.
Change digit Change digit
4. Proceed to the setting number by pressing the POWERFUL button. (To return to the function
number selection, press the POWERFUL button again.)
5. Select the function number by pressing the or the button. Each time the 10 °C HEAT but-
ton is pressed, it switches between the right digit and the left digit.
Change digit
- 302 -
15-3. Indoor unit (setting by wireless remote controller)
15. Function settings
4-5 UNIT MULTI-SPLIT TYPE 4-5 UNIT MULTI-SPLIT TYPE

Fujitsu ARXG14KLLAP Specifications

General

Brand	Fujitsu
Model	ARXG14KLLAP
Category	Air Conditioner
Language	English